Watt Lanzar

i have 2 orion hcca's (2000 watt rms & 4000 watt peak) and 2 Lanzar VCT2230 3100W amps?

Can anyone tell me what else i need to be able to hook this system up ( all the upgrades that i'll need to do and etc.)? Any help would be greatly appreciated.

you wont need to do any upgrades because its not that much power
when it comes to car audio you always get what you pay for and that amps wattage is very over rated (you would be lucky to get a quarter of the advertised wattage)
you need to buy an amp that is CEA-compliant (has been tested, not over rated, and puts out the advertised wattage or more)

CEA-2006 Compliant
On May 28, 2003, the Consumer Electronics Association published standard CEA-2006, "Testing & Measurement Methods for Mobile Audio Amplifiers." This "voluntary" standard advocates a uniform method for determining an amplifier's RMS power and signal-to-noise ratio. Using 14.4 volts, RMS watts are measured into a 4-ohm impedance load at 1 percent Total Harmonic Distortion (THD) plus noise, at a frequency range (for general purpose amplifiers) of 20 Hz to 20,000 Hz. Signal-to-Noise ratio is measured in weighted absolute decibels (dBA) at a reference of 1 watt into 4 ohms. This applies to both external amplifiers and the amplifiers within in-dash receivers.

CEA-2006 allows consumers to be able to compare car amplifiers and receivers on an equal basis. Manufacturers who choose to abide by the new standard are able to stamp their products with the CEA-2006 logo that reads: "Amp Power Standard CEA-2006 Compliant."

here are the CEA-compliant brands
Alpine
Bazooka
Blaupunkt
Clarion
Eclipse
Infinity
JBL
JL Audio
Kenwood
Kicker
MTX
Pioneer
Polk Audio
Rockford Fosgate
Sony

Can"t find what you are looking for? Check out these products from Amazon.