Soundstream Picasso

Which is a better subwoofer?

Soundstream 15" R1 Reference (4 ohm) (1300w RMS/2000w Peak)

Alpine 15" Type-R (2 ohm) (750w RMS/2000w Peak)

Kicker 15" L7 (2ohm) (1000w RMS/2000w Peak)

Which one is a better subwoofer for pounding???

Amp: PCX2000D Soundstream Picasso Amp
Just opinions on these products please! I appreciate the other comments just really looking at these, practically heart set!

the L7 will blow the alpine out the water in SPL
the type-r will sound a little better in the SQ department
the soundstream is trash, mediocre at best

i would not hook up either of those subs to that amp because it has the same build quality as their subs- terrible

but if you already have the amp you may be safe for a while if you are VERY careful with you amp settings
If you send too much power to your sub, you risk damaging it. The cone of the speaker and the mechanical parts that make it move may break under the stress. Surprisingly, too little power can also damage your subwoofer — in fact, it's actually more common than damage caused by overpowering.
When the volume is turned up and the amp doesn't have enough power, the signal becomes distorted, or "clipped." This distorted signal can cause parts of the speaker to overheat, warp and melt. Not good!
You don't have to match speaker and amp wattages exactly. An amp with a higher output than the speaker's rating won't necessarily damage the speaker — just turn the amp down a bit if you hear distortion from the sub and don't run the speaker at extremely loud volumes for lengthy periods. Likewise, you'll be OK with a lower powered amp if you keep the volume down and don't feed a distorted signal to the sub
you will send the amp into clipping
Clipping
Clipping occurs when an amplifier is asked to deliver more current to a speaker than the amp is capable of doing. When an amplifier clips, it literally cuts off the tops and bottoms of the musical waveforms that it's trying to reproduce, thus the term. This introduces a huge amount of distortion into the output signal. Clipping can be heard as a crunching sound on musical peaks.
that causes distorted sound which will damage your subs over time

to maximize clean signal strength from your amp, you need to adjust the gain or input sensitivity settings. Here's how:
Set the input sensitivity controls of your amplifier to their minimum level (counter clockwise).
Put in a CD and turn the receiver's volume control up (you might have to raise the amp's gain just a bit to hear the music).
When you hear distortion, stop. Turn the volume down until it disappears. As much signal as possible is passing from the receiver to the amp. This maximizes the signal-to-noise ratio, and leaves your system less prone to engine noise problems. Keep the volume setting here.
Now turn the gain controls on the amplifier up until it's as loud as you'll play it. If you hear distortion, slightly decrease the gain settings.
Now you've optimized the amp's output with the receiver's volume set near maximum. You can turn the volume almost all the way up and not damage your speakers or amplify distortion. If you're hooking up a subwoofer, a test disc (or bass-heavy CD) is helpful for making final adjustments

Can"t find what you are looking for? Check out these products from Amazon.