Amplifier Kac

Would a kenwood Kac-X10D amp work with 2 KFC-3011 subs?

I have 2 12 inch KFC-3011 subs. I want to but a KAC-X10D amplifier for the subs but I was wondering if this would work. NEED HELP SOON!!!!

it would power them but i would get something with more wattage, about 800watts RMS @ 2ohms (that would have them sounding their best)
this is the one i would recommend http://www.kenwoodusa.com/Car_Entertainment/eXcelon/Amplifiers/KAC-X1R

If you send too much power to your sub, you risk damaging it. The cone of the speaker and the mechanical parts that make it move may break under the stress. Surprisingly, too little power can also damage your subwoofer — in fact, it's actually more common than damage caused by overpowering.
Even the toughest sub, however, can be damaged by excessive distortion from a clipped signal.
When the volume is turned up and the amp doesn't have enough power, the signal becomes distorted, or "clipped." This distorted signal can cause parts of the speaker to overheat, warp and melt. Not good!
You don't have to match speaker and amp wattages exactly. An amp with a higher output than the speaker's rating won't necessarily damage the speaker — just turn the amp down a bit if you hear distortion from the sub and don't run the speaker at extremely loud volumes for lengthy periods. Likewise, you'll be OK with a lower powered amp if you keep the volume down and don't feed a distorted signal to the sub.

Can"t find what you are looking for? Check out these products from Amazon.